Diagramma di flusso orizzontale Smart Diagram

Question

Voglio collegare il mio blocco DT a LL nella seguente trama

Il codice seguente è:

\begin{center}
\begin{figure}


\smartdiagramset{set color list={blue!10, blue!30,blue!50},back arrow disabled=true,
additions={
additional item offset=0.4cm,
additional arrow color=blue!30,
additional arrow tip=stealth,
additional arrow line width=1pt,
additional item border color=gray,
additional item shape=rounded corners,
additional item bottom color=blue!30,
additional item shadow=drop shadow
}
}
\smartdiagramadd[flow diagram:horizontal]{WRA, LL, CM}{
above of module2/DT
}
%\smartdiagramconnect{->}{module2/additional-module2n}
\end{figure}
\end{center

}

Tuttavia, quando provo a collegare il nuovo blocco al modulo 2, ricevo un errore. Affermare che "additional-module2" non è noto. Qualche suggerimento?

Answer 1

Modifica: il tuo problema puoi risolvere in due modi:

• Con l'aggiunta alla additionsriga di codice additional connections disabled=false, :
• O per aggiungere il codice del diagramma \smartdiagramconnect{to-}{module2/additional-module1}

Primo esempio:

\documentclass[rgb]{article}
\usepackage{smartdiagram}
\usesmartdiagramlibrary{additions}

\begin{document}
    \begin{figure}
    \centering
\smartdiagramset{set color list={blue!10, blue!30,blue!50},back arrow disabled=true,
additions={
additional item offset=0.4cm,
additional connections disabled=false,  % NEW
additional arrow color=red,             % changed color ...
additional arrow tip=stealth,
additional arrow line width=2pt,        % changed thickness
additional item border color=gray,
additional item shape=rounded corners,
additional item bottom color=blue!30,
additional item shadow=drop shadow
}
}
\smartdiagramadd[flow diagram:horizontal]%
    {WRA, LL, CM}%
    {above of module2/EDT}
%
\caption{Smart diagram}
\label{fig:smartdiagram}
    \end{figure}
\end{document}

Secondo caso:

\documentclass[rgb]{article}
\usepackage{smartdiagram}
\usesmartdiagramlibrary{additions}

\begin{document}
    \begin{figure}
    \centering
\smartdiagramset{set color list={blue!10, blue!30,blue!50},back arrow disabled=true,
additions={
additional item offset=0.4cm,
additional arrow color=red,             % changed color ...
additional arrow tip=stealth,
additional arrow line width=2pt,        % changed thickness
additional item border color=gray,
additional item shape=rounded corners,
additional item bottom color=blue!30,
additional item shadow=drop shadow
}
}
\smartdiagramadd[flow diagram:horizontal]%
    {WRA, LL, CM}%
    {above of module2/EDT}
\smartdiagramconnect{to-}{module2/additional-module1}
%
\caption{Smart diagram}
\label{fig:smartdiagram}
    \end{figure}
\end{document}

In entrambi i casi il risultato è lo stesso: